 | Digi-Pulse Flow Monitors
Digi-Pulse Flow Monitors solve the age-old question “How do I know if my pump is pumping?” This innovative product is designed to be used with our Type “9” Metering Pumps to provide the user with verification of pump performance. If the Flow Monitor detects output loss, it will shut the pump off and close a switch that may be tied to an alarm. The alarm signal may also be used to trigger a stand-by pump. |
 | Chemical Storage Tanks
LMI manufactures storage tanks in 10, 35, and 50 gallon sizes. All tanks have a molded in recess for an LMI Metering Pump. The 35 Gallon Tank features a pump mounting location at the base of the tank providing flooded suction which is ideal for off-gassing chemicals and applications where very low output is required. All tanks feature heavy wall construction of UV resistant polyethylene. |
 | Remote Flowmeter Pulsers
LMI's RFP Remote Flowmeter Pulser provides a simple method to feed chemical in proportion to water flow. All that is required is the Flowmeter Pulser and the appropriately sized LMI Pump. The wall mount divider may be installed up to 100 feet from the flowmeter for easy user access. No other timers, relays or control valves are required. Flowmeters are available from 3/4” to 6” for flow rates from 0.44 to 1300 GPM. |
 | Back Pressure/Pressure Relief Valves
LMI's diaphragm back pressure/anti-syphon valves apply positive discharge pressure to a metering pump system and act to stabilize the output of higher output LMI Metering Pumps when pumping into low or no-pressure systems. Pressure relief valves are designed to protect chemical feed systems from overpressure damage caused by defective equipment or deadheading. Valves are available in 1/4”, 1/2”, and 1” sizes in PP, PVC, PVDF, and 316SS. |
 | Agitators
LMI offers a range of agitators with fractional horsepower motors to fit our 35 and 50 gallon tanks. Impellers are available in Neoprene R and epoxy coated stainless steel for a wide variety of chemicals. Mounting hardware and a pump suction tube wand are included to complete the installation. |
 | Calibration Cylinders
Installation of a calibration cylinder on the suction side of your LMI pump simplifies calibration. LMI offers Calibration Cylinders in 200 ml, 1000 ml, and 4000 ml sizes to fit most LMI pump capacities. Removable tops and sealed tops are available. See the drawings in the Technical Service Section for typical installations. |